Step 1
|
The 1st Layer When the layer is fully solved, your cube will look like this:
No specific algorithm.
The placement of the pieces should remain intuitive.
Here are the main steps:
|
The Centers
|
The Edges
|
The Corners
|
|
Step 2
|
The Edges of the 2nd Layer Once all the edges have been solved, your cube will look like this:
|
Case a The green/red edge is on the 3rd layer to the right
The algorithm allows you to place it on the 2nd layer.
|
Case b The green/red edge is on the 3rd layer opposite
The algorithm allows you to place it on the 2nd layer.
|
Case c The green/red edge is placed on the 2nd layer and incorrectly oriented
The algorithm allows you to move it down to the 3rd layer.
You can then apply the algorithm from case a.
|
|
Step 3.1
|
Orienting the edges of the 3rd layer When all the edges have been processed, your cube will look like this:
|
Case a The edges already oriented are side by side
The algorithm will orient the Front/Right edges.
|
Case b The edges already oriented are opposite each other
This formula will orient the Left/Right edges.
|
Case c
No oriented edges
The algorithm will orient the Left/Back edges.
You can then apply the algorithm from case a.
|
|
Step 3.2
|
Placement of the 3rd Layer Edges When all the edges have been processed, your cube will look like this:
|
Case a The edges already placed are side by side
The algorithm will place the Left/Front edges.
|
Case b The edges already placed are opposite each other
This formula will place the Front/Back edges.
You can then apply the algorithm from case a.
|
|
Step 4
|
The Corners of the 3rd Layer When all the corners have been processed, your cube will look like this:
|
Place the Corners The algorithm will swap the corners (except the one in front of you on the right) clockwise.
Depending on your setup, you should apply the algorithm a maximum of 2 times!
The orientation of the corners can vary. What matters is their position.
(The 3 colors of each corner must correspond to the 3 theoretical faces of the corner)
|
Orienting the Corners The algorithm will allow you to orient the 2 corners on your right upwards.
Depending on your setup, you should apply the algorithm a maximum of 2 times!
Remember to orient your cube correctly so as not to perform the algorithm more than necessary, i.e., not necessarily with the 6th layer at the top.
|
|