Step 1
|
The first layers When the layers are fully processed, your cube will look like this:
No particular algorithm.
The placement of pieces must remain intuitive.
Here are the main steps:
|
The first layer
|
The second layer
|
The third layer
|
The fourth layer
|
The fifth layer
|
The sixth layer
|
|
Step 2
|
The edges of the last layer When the edges have been processed, your cube will look like this:
|
Orient the edges - Case a
1 single edge well oriented
This formula will make it possible to obtain 3 well-oriented contiguous edges.
|
Orient the edges - Case b
3 contiguous edges well oriented
This formula will make it possible to obtain 3 well-oriented non-contiguous edges.
|
Orient the edges - Case c
3 non-contiguous edges well oriented
This formula will allow you to obtain 5 well-oriented edges.
|
Place the edges
The algorithm will perform a circular permutation of the 3 edges in position 3, 4, 5.
|
|
Step 3
|
The corners of the last layer When the corners have been processed, your cube will look like this:
|
Place the corners
The algorithm will swap the 3 left corners clockwise.
Depending on your configuration, you should apply the algorithm 3 or 4 times maximum!!!
Corner orientation may vary. What matters is the location.
(The 3 colors of each corner must correspond to the 3 theoretical faces of the corner)
|
Orient the corners
The algorithm will allow you to orient the 2 corners of your right upwards.
Depending on your configuration, you should apply the algorithm 3 or 4 times maximum!!!
Remember to orient your cube correctly so as to avoid performing the algorithm more than necessary, that is to say not necessarily the 3rd layer at the top.
|
|