Step 3
The corners of the last layer Once the corners have been processed, your cube will look like this:
|
Place the corners - case a
The algorithm will swap the 3 left corners clockwise.
Depending on your setup, you should apply the algorithm a maximum of 3 or 4 times!!!
The orientation of the corners can vary. What matters is the placement.
(The 3 colors of each corner must correspond to the 3 theoretical faces of the corner)
|
Place the corners - case b
The algorithm will swap the 3 right corners counterclockwise.
Depending on your setup, you should apply the algorithm a maximum of 3 or 4 times!
The orientation of the corners can vary. What matters is the placement.
(The 3 colors of each corner must correspond to the 3 theoretical faces of the corner)
|
Orienting the Corners
The algorithm will allow you to orient the 2 corners on your right upwards.
Depending on your setup, you should apply the algorithm a maximum of 3 or 4 times!
Remember to orient your cube correctly so as not to perform the algorithm more than necessary, i.e., not necessarily with the 3rd layer at the top.
|
|