Step 1
The 1st layer When the layer is fully solved, your cube will look like this:
No particular algorithm.
The placement of the pieces should remain intuitive.
Here are the main steps:
|
The centers
|
The edges
|
The corners
|
|
Step 1 bis
The centers of the 2nd layer
You must ensure that all centers are correctly oriented; if so, everything is fine.
Otherwise, you have 3 cases for each incorrectly oriented center.
Place the centers to be oriented as shown opposite.
When all the centers are correctly oriented, your cube will look like this:
|
Half turn
|
Quarter turn counterclockwise
|
Quarter turn clockwise
|
|
Step 2
Edges of the 2nd layer When all the edges have been processed, your cube will look like this:
|
Place the edges - case a
The edge to be placed is on the 3rd layer
It is on the right The algorithm allows you to place it on the 2nd layer.
|
Place the edges - case b
The edge to be placed is on the 3rd layer
It is opposite The algorithm allows it to be placed on the 2nd layer.
|
Place the edges - case c
The edge to be placed is on the 2nd layer
It is incorrectly oriented The algorithm allows it to be moved down to the 3rd layer and then put back in place, but correctly oriented.
|
|
Step 3.1
Orientation of the edges of the 3rd layer When all the edges have been processed, your cube will look like this:
|
Orient the edges - case a
2 edges are correctly oriented
They are adjacent The algorithm will orient the Front/Right edges.
|
Orient the edges - case b
2 edges are correctly oriented
They are opposite The algorithm will orient the Left/Right edges.
|
Orient the edges - case c
No edges are correctly oriented The algorithm will orient all edges.
|
|
Step 3.2
Place the edges of the 3rd layer When all edges have been processed, your cube will look like this:
|
Place the edges - case a
2 edges are correctly placed
They are adjacent The algorithm will place the Left/Front edges.
|
Place the edges - case b
2 edges are correctly placed
They are opposite The algorithm will place the Front/Back edges.
|
|
Step 4
The corners of the 3rd layer When all the corners have been processed, your cube will look like this:
|
Place the corners - case a The algorithm will swap the corners (except the one in front of you on the right) clockwise.
Depending on your setup, you should apply the algorithm a maximum of 2 times!!!
The orientation of the corners can vary. What matters is the placement.
(The 3 colors of each corner must correspond to the 3 theoretical faces of the corner)
|
Place the corners - case b The algorithm will swap the corners (except the one in front of you on the left) counterclockwise.
Depending on your setup, you should apply the algorithm a maximum of 2 times!!!
The orientation of the corners can vary. What matters is the placement.
(The 3 colors of each corner must correspond to the 3 theoretical faces of the corner)
|
Orient the corners The algorithm will allow you to orient the 2 corners on your right upwards.
Depending on your setup, you should apply the algorithm a maximum of 2 times!!!
Remember to orient your cube correctly to avoid performing the algorithm more than necessary, meaning not necessarily with the third layer on top.
|
|
Step 5
The center of the third layer When the center is correctly oriented, your cube will look like this:
|
|